Fist off, huge thanks to these people:

-Ryuinferno - His init.d on any device method
-Matt on code.google.com - Old touch driver and temp install method

Disclaimer:

-I am not responsible for any damage this may cause.... (You've seen this a billion times so I'll leave it at that)

What this does:

-Enables init.d by adding a command into install-recovery.sh to run anything in /system/etc/init.d (method by Ryuinferno)
-Extracts the E015 driver to /system for safe keeping and script usage (E015 is a downgrade of the touch driver that senses touch better)
-Adds an init.d script that changes the touchscreen driver to E015 on every boot (driver supplied by Matt and so was the temp-replace method. It runs his method on every boot essentially.)
-Sends log to /data/Driver.log so user can check proper installation if desired

The advantage of using this over using a kernel with E015 in it is that it does not mess with custom recovery touch sensing.

Instructions:

-THIS WILL NOT WORK UNLESS BUSYBOX IS INSTALLED! You can install it with this app.
-Download the zip from here
-Flash it in a custom recovery. If you don't know how to flash a recovery / root / flash a zip, there are plenty of tutorials floating around.

If you want to undo this:

-Flash this zip through recovery.

Enjoy!


PS: Bei meinem Gerät war es nicht unbedingt nötig d.h hatte keine Probleme zuvor wie andere aber mit dem Mod habe ich den Eindruck, dass es nochmals einen Tick besser geht. Der Screen reagiert prompt und ich kann es jedem empfehlen! *Immer zuerst Backup erstellen und an solche Sachen ran gehen